Skip to content
Keep it dry! These breather patches allow air to vent out of a headlight, but block moisture from coming in. This is a big help in preventing condensation from building up inside.
Available in packs of 4 or 40 units, the circle stickers are 20mm in diameter, or just over 3/4 inches. They are designed to be placed over a 1/2-inch hole. We recommend using two per lamp to provide maximum airflow.
To install, drill a 1/2-inch hole on your lamp. We recommend placing at the side, but you can choose anywhere that has a flat surface. Clean the hole and stick on the patch, holding firmly for 5 seconds to ensure good adhesion. That's it!
Installation
Tools Needed: Basic Toolset
FAQ
The Breather Patch is a specialized adesive patch designed to allow air in and out of the patch while preventing moisture, dust, and debris from entering.
This allows for better air flow in and out of the headlight to reduce condensation and moisture build up over time.
- Clean the Area: Ensure the surface around the breather hole is clean and dry.
- Drill a small hole: in the headlight assembly. Ensure the hole is smaller than the size of the breather patch
- Apply the Patch: Place the 20mm Headlight Breather Patch over the hole you create.
- Secure the Patch: Press down firmly to ensure a tight seal. The adhesive backing will help it stay in place.
Yes, the Headlight Breather Patch is designed to be waterproof, providing a reliable seal to protect the headlight from moisture and dust.
The Headlight Breather Patch is intended for single-use applications. Reusing it will affect its adhesive properties and sealing effectiveness.
The breather patch is recommended to be installed on the backside of the headlight assemby around the middle of the headlight.
There is not a specific best spot. Anywhere in this area should suffice .