Skip to content
This installation reference covers 2014-2023 Infiniti Q50 Multicolor DRL Boards. Match the product, vehicle configuration and controller part number before starting.
Part # F5
Infiniti Q50 Multicolor Flow DRL Boards (2014-2024)
Install GuideStep 1: Test your Product. This helps you check operation and confirm the wiring before permanent installation. See the wiring guide that comes with your product or visit our Wiring Guide.
Step 2: Remove your bumper to access headlights.
Step 3: Open your headlights. We recommend using the baking method. (*Confirm the opening and resealing method for your exact housing before following the video below).
Step 4: Install your LED Product into your headlights.
Important Note for Flow Series Kits
The RGBW version shown in the video below has been discontinued and replaced by our Flow Series version.
For the Flow Series kit, the process for opening the headlights and installing the eyebrow portion is the same as shown in the video below. However, the installation of the lower strip/line DRL section is different because the Flow version uses a custom LED strip instead of replacement RGBW boards.
For the correct Flow Series strip installation process, please reference this updated video: https://youtube.com/shorts/CniUbo4Vg-w?si=B-bFJpitHRmACe6h
Step 5: Reseal your headlights (see video above) or click here for full guide.
Step 6: If you haven't already, wire your LED Product onto your car using the included wiring guide or see our wiring guide.
Additional installation videos
These earlier demonstrations may show a different controller revision. Use the current kit-specific wiring instructions above for your supplied hardware.
Source and installation help
Checked against 2014-2023 Infiniti Q50 Multicolor DRL Boards Install Guide in the RGB Halo Kits Help Center on October 22, 2026. Follow the instructions supplied with your exact kit if hardware versions differ.
Controller and wiring guide · Ask installation support · Browse lighting guides
