Skip to content
This installation reference covers 2014-2019 Chevrolet Corvette DRL Boards. Match the product, vehicle configuration and controller part number before starting.
Part # E13, E14
Chevrolet Corvette Multicolor DRL Boards (2014-2019)
Install Guide
Step 1: Test your Product. This helps you check operation and confirm the wiring before permanent installation. See the wiring guide that comes with your product or (visit our wiring guide.
Step 2: Remove your bumper to access headlights.
Step 3: Open your headlights. We recommend using the cutting method on this headlight. (*Confirm the opening and resealing method for your exact housing before following the video below)
Step 4: Install your LED Product into your headlights.
Step 5: Reseal your headlights (see video above)
Step 6: If you haven't already, wire your LED Product onto your car using the included
RGBW Bluetooth LED Controller Wiring Guide – RGB HALO KITS
Flow Series Bluetooth Controller w/ DRL SmartSwitch - Install Guide
Additional installation videos
These earlier demonstrations may show a different controller revision. Use the current kit-specific wiring instructions above for your supplied hardware.
Source and installation help
Checked against 2014-2019 Chevrolet Corvette DRL Boards Install Guide in the RGB Halo Kits Help Center on October 22, 2026. Follow the instructions supplied with your exact kit if hardware versions differ.
Controller and wiring guide · Ask installation support · Browse lighting guides
