How to Cut power to Multicolor Lights Manually

How to Cut power to Multicolor Lights Manually

If your controller fails or disconnects, causing the lights to remain on...

In the event that your controller is not working or loses connection or is not responding to the lights and your lights are stuck on, you may need to manually cut power to the lights until you get a new controller.

Here is how to manually cut power to your lights. 

Your multicolor lights will likely be powered straight to the battery. The power wire is usually red with some black wire protector or braid over the wire. Located on the red wire will be an inline fuse protector. This is to protect against any accidental positive/negative wire touches or short circuits, etc. 

Step 1: Located the red 10amp inline fuse found on the positive wire of your controller. This will be housed in a little black cap. inline_fuse_10amp_.webp


Step 2: pull out the red inline fuse. (This will cut power to the multicolor lights 


Step 3. if you want to reset the system push back in and see if the controller or app is working again. If not working, then leave the fuse out until you get a replacement controller.

Leave a comment

All comments are moderated before being published.

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.