This installation reference covers 2010-2013 Infiniti G37 Sedan Spyder Headlights Multicolor DRL Boards. Match the product, vehicle configuration and controller part number before starting.
2010-2013 Infiniti G37 Sedan Spyder Headlights Multicolor DRL Boards
Please note that these are DRL Boards Only that fit spyder aftermarket headlights.Step 1: Test your Product. This helps you check operation and confirm the wiring before permanent installation. See the wiring guide that comes with your product or visit our wiring guide.
Step 2: Remove your bumper to access headlights.
Step 3: Open your headlights. We recommend using the baking method. (*Confirm the opening and resealing method for your exact housing before following the video below)
Step 4: Install your LED Product into your headlights.
Flow Series Bluetooth Controller w/ DRL SmartSwitch - Install Guide
Step 5: Reseal your headlights (see video above) or click here for full guide.
Additional installation videos
These earlier demonstrations may show a different controller revision. Use the current kit-specific wiring instructions above for your supplied hardware.
Source and installation help
Checked against 2010-2013 Infiniti G37 Sedan Spyder Headlights Multicolor DRL Boards Install guide in the RGB Halo Kits Help Center on October 22, 2026. Follow the instructions supplied with your exact kit if hardware versions differ.
Controller and wiring guide · Ask installation support · Browse lighting guides
